How to create vacuum(etching device) analysis

K.M · December 2, 2017, 22:58

Hello everyone

This is my first post.

I am analyzing etching equipment. Although the etching apparatus originally uses plasma, I want to treat the plasma as a thermal fluid and know how much heat acts on the inner wall of the etching apparatus.
I would like to release thermal fluid (gas other than air) from the inlet of the image below into the vacuum domain (air). What should I do? Also, which model should be used? I think this is a multiphase flow of air (close to vacuum) and some kind of gas.

vijaybr1993 · July 25, 2018, 10:38

KOEI MIYATA,

could you please assist me if you found the solution to create vacuum

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	91	December 21, 2022 04:50
[ICEM] How can I create prism mesh for a 3D domain surrounded by a torus?	lzgwhy	ANSYS Meshing & Geometry	5	May 18, 2017 17:10
Medical Image Processing Softwares with CFD Analysis and 3D Printing Capabilities	CornBlitz	Main CFD Forum	3	December 15, 2016 05:05
Acoutic fan analysis	arunraj	CFX	3	October 4, 2012 18:54
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07

July 25, 2018, 10:38		#2
vijaybr1993 New Member asdf;lkj Join Date: Jul 2018 Posts: 6 Rep Power: 7	KOEI MIYATA, could you please assist me if you found the solution to create vacuum