|
[Sponsors] |
August 14, 2018, 10:26 |
Change units of animation
|
#1 |
New Member
Join Date: Dec 2017
Posts: 12
Rep Power: 8 |
Hi,
I have all my animation files (.hsf) for a completed run, but the colorbar is in m/s. I need it in ft/s. Is there a way in Fluent (or even CFD-Post) to convert the units displayed in the colorbar? Thanks |
|
August 14, 2018, 12:58 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,679
Rep Power: 66 |
In the GUI go too setting up the domain => units and you can change all the units used by Fluent.
In the TUI you can use: Code:
define/units velocity ft/s |
|
August 14, 2018, 13:28 |
|
#3 |
New Member
Join Date: Dec 2017
Posts: 12
Rep Power: 8 |
Yes that would work before a run was made.
I did try to change the units there, but that doesn't change how the colorbar is displayed when doing a playback. It will changes the units of the contour plot that is used for animation, but not the colorbar on the animation. I'm looking at how to change the units of the colorbar on an animation after the run has been completed. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Thermophysical Property Units | johanz | OpenFOAM Pre-Processing | 2 | December 16, 2018 10:08 |
units in OpenFOAM | megacrout | OpenFOAM | 4 | July 19, 2011 08:04 |
Change cell zone index/thread during simulation | neilduffy1024 | FLUENT | 0 | January 17, 2011 09:40 |
Animation in Tecplot | ryoga | Tecplot | 0 | February 18, 2002 11:19 |