|
[Sponsors] |
September 5, 2018, 14:58 |
Enclosure with one surface against base
|
#1 |
New Member
Join Date: Aug 2018
Posts: 5
Rep Power: 7 |
Hi ,
I am working on simulating the airflow on a part. However I want the enclosure to match with the base of my part.In other words I do not want air flowing under it. FLUENT dosen't allow me to make an enclosure with cushion 0. Is there a way to do it? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Surface triangulation using snappyHexMesh | shaileshbg | OpenFOAM Meshing & Mesh Conversion | 4 | October 17, 2019 04:42 |
How To Create Fowcs William Hawkings Surface in Fluent? | marinkobezu | FLUENT | 7 | October 25, 2018 10:51 |
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM? | jash | ANSYS Meshing & Geometry | 19 | July 23, 2013 18:48 |
[snappyHexMesh] Add additional boundary layers to complex stl surface | tobijingles | OpenFOAM Meshing & Mesh Conversion | 1 | October 26, 2011 10:45 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |