|
[Sponsors] |
|
October 22, 2018, 03:56 |
Non-comformal two cell zone -Mesh Interface
|
#1 |
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 12 |
Hello guys,
I have modelled two cell zones (actually more than two cell zones) and they are non-comformal interfaces then how should I define their interface? Coupled wall Matching Mapped Static I haven't made selection in mesh interface. Is it a correct approximation? Objecitve is to see the pressure drops through all cell zones? Best Regards, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
[GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |