Non-comformal two cell zone -Mesh Interface -- CFD Online Discussion Forums

October 22, 2018, 03:56	Non-comformal two cell zone -Mesh Interface	#1
oozcan Senior Member Onur Özcan Join Date: Feb 2016 Location: Istanbul/Turkey Posts: 461 Rep Power: 12	Hello guys, I have modelled two cell zones (actually more than two cell zones) and they are non-comformal interfaces then how should I define their interface? Coupled wall Matching Mapped Static I haven't made selection in mesh interface. Is it a correct approximation? Objecitve is to see the pressure drops through all cell zones? Best Regards,

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 07:30
My radial inflow turbine	Abo Anas	CFX	27	May 11, 2018 01:44
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 11:25
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05

All times are GMT -4. The time now is 12:39.