Total mass out

Murilo mec · November 9, 2018, 12:22

Hi everyone. I'm working on a transient simulation of air flow inside a duct on ansys fluent. I need the total mass of air that exits the duct, however i'm not certain of how to do that. Has anybody done something similar?

thankyou.

LuckyTran · November 9, 2018, 12:43

Create a monitor/report of the mass flow and export the transient instantaneous mass flowrate for all timesteps and dump it into a text file. Then read it into excel/matlab or whatever and integrate it in time.

Murilo mec · November 9, 2018, 13:27

thankyou very much. I believe i'll have to run the calculation again, because i set the massflow monitor but i haven't selected the "report File" option.

LuckyTran · November 9, 2018, 13:40

Yes you'll need to run it all over again. The .dat file only contains the current solution, all history of the solution is lost.

There are other ways to set it up using a possibly very complicated udf that does the same task as writing to a text file and integrating yourself. But either way you need to rerun it.

November 9, 2018, 12:22	Total mass out	#1
Murilo mec New Member Murilo Join Date: Nov 2018 Posts: 2 Rep Power: 0	Hi everyone. I'm working on a transient simulation of air flow inside a duct on ansys fluent. I need the total mass of air that exits the duct, however i'm not certain of how to do that. Has anybody done something similar? thankyou.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inconsistencies in reading .dat file during run time in new injection model	Scram_1	OpenFOAM	0	March 23, 2018 22:29
Total injected mass in 60 degree sector	sanket31594	CONVERGE	6	July 21, 2017 04:26
Interphase mass transfer of a reaction	cfx_ws1992	Main CFD Forum	0	May 15, 2017 21:42
Segmentation fault (core dumped)	zhoubiao1088	OpenFOAM Running, Solving & CFD	4	March 13, 2017 20:06
Continuity Residual high but total mass convergence achieved?	MichaelStark331	FLUENT	1	February 8, 2016 10:24

November 9, 2018, 12:43		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,676 Rep Power: 66	Create a monitor/report of the mass flow and export the transient instantaneous mass flowrate for all timesteps and dump it into a text file. Then read it into excel/matlab or whatever and integrate it in time.

November 9, 2018, 13:27		#3
Murilo mec New Member Murilo Join Date: Nov 2018 Posts: 2 Rep Power: 0	thankyou very much. I believe i'll have to run the calculation again, because i set the massflow monitor but i haven't selected the "report File" option.

November 9, 2018, 13:40		#4
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,676 Rep Power: 66	Yes you'll need to run it all over again. The .dat file only contains the current solution, all history of the solution is lost. There are other ways to set it up using a possibly very complicated udf that does the same task as writing to a text file and integrating yourself. But either way you need to rerun it.