Keeping cell zone on single node

Ruan_Eng · January 29, 2019, 06:23

Hi all,

I am busy coding a UDF in Fluent which requires cell data from an upstream and downstream cell in order to calculate relevant source terms. However, as far as I understand cell linkup is not possible if each cell is partitioned on different nodes during parallel computations. Is there any way to 'hold' a cell zone on a single node?

Thanks

QIAN917918 · May 28, 2019, 09:15

Hi,

I has a problem like this and want to exchage the information on both sides of the paratition face. Have you solved this problem?

Thanks

January 29, 2019, 06:23	Keeping cell zone on single node	#1
Ruan_Eng New Member Ruan Engelbrecht Join Date: Jul 2015 Posts: 2 Rep Power: 0	Hi all, I am busy coding a UDF in Fluent which requires cell data from an upstream and downstream cell in order to calculate relevant source terms. However, as far as I understand cell linkup is not possible if each cell is partitioned on different nodes during parallel computations. Is there any way to 'hold' a cell zone on a single node? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] RefineMesh Error and Foam warning	jiahui_93	OpenFOAM Meshing & Mesh Conversion	4	March 3, 2018 11:32
Running UDF with Supercomputer	roi247	FLUENT	4	October 15, 2015 13:41
About Cell Zone Conditions	Liufeng_ustb	FLUENT	0	May 17, 2013 23:28
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52

May 28, 2019, 09:15		#2
QIAN917918 New Member Qian Yang Join Date: May 2019 Posts: 1 Rep Power: 0	Hi, I has a problem like this and want to exchage the information on both sides of the paratition face. Have you solved this problem? Thanks