|
[Sponsors] |
how can i perform surface suction or delaying boundary layer separation? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 22, 2019, 07:46 |
how can i perform surface suction or delaying boundary layer separation?
|
#1 |
New Member
sirak masresha
Join Date: Dec 2017
Posts: 11
Rep Power: 8 |
hey friends, how are you doing? if you don't mind, i need your help. i am studying flow over an aircraft wing to (improve) increase the lift at high angle of attack by delaying boundary layer separation on the method of suction on the wing upper surface and near to 3/4 chord, then i need to simulate the flow analysis by using ANSYS fluent, and what are the procedures and the step?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
Out File does not show Imbalance in % | Mmaragann | CFX | 5 | January 20, 2017 10:20 |
[snappyHexMesh] Problem with Sanpper, surface still Rough | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 7 | November 5, 2014 12:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |