|
[Sponsors] |
June 18, 2019, 16:49 |
How to select wall zones for drag monitor.
|
#1 |
New Member
Punjab
Join Date: Jun 2019
Posts: 2
Rep Power: 0 |
Hello everyone,
I am doing simulation of a 3D airfoil under ground effect in ANSYS Fluent.I am unable to understand which wall zones to select in the drag monitor.The two option being shown to me are- 1.Wall solid 2.Ground Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simple piston movement in cylinder- fluid models | arun1994 | CFX | 4 | July 8, 2016 03:54 |
Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 09:16 |
LES in DES can't be actived! | shenying0710 | CFX | 17 | January 23, 2014 05:45 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
UDF to monitor minimum pressure on the wall | Arvind Jayaprakash | FLUENT | 0 | September 20, 2007 12:53 |