Pressure cooker water boiling simulations in ANSYS fluent -- CFD Online Discussion Forums

August 13, 2019, 06:57	Pressure cooker water boiling simulations in ANSYS fluent	#1
prasadik New Member Prasad Kulkarni Join Date: Aug 2019 Posts: 1 Rep Power: 0	I am performing ANSYS - FLUENT simulations for pressure cooker with water filled in half the volume of pressure cooker. Aim of the simulation is to calculate the energy required for increasing temperature of water inside pressure cooker fromf 27 degree Celsius to 100 degree Celsius. So, how should I define the end condition of this simulation so that software will stop the simulation at the point when temperature of all the water reaches to boiling point and then calculate the energy required for heating water?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 22:56
Surface Pressure Gradient at Heaving Airfoil in ANSYS Fluent	saifullahkhalid	FLUENT	0	November 11, 2013 04:17
Export pressure from ansys to fluent	ermes	ANSYS	4	June 7, 2010 07:24
Different kinds of pressure in FLUENT	Mattia	FLUENT	0	October 22, 2007 08:52
uptodate water distribution network	fredius,magige,tanzanian,(e.a)	Main CFD Forum	0	January 27, 2002 07:10

All times are GMT -4. The time now is 23:29.