|
[Sponsors] |
How to apply periodic border conditions in the Mesh interfaces in ANSYS fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2019, 14:41 |
How to apply periodic border conditions in the Mesh interfaces in ANSYS fluent
|
#1 |
New Member
AHMAD ABOULKHAIL
Join Date: Nov 2018
Location: Turkey
Posts: 9
Rep Power: 7 |
hello
I try to apply periodic boundary conditions to a flow model in a heat exchanger, the model consists of part of a plate and a hot and cold fluid as shown in the attached image. In the Mish Interfaces section, the periodic boundary condition is set as shown in the attached picture. But the results were illogical. My question is whether the method you used is correct and whether the options you have chosen for the flow direction and type are related to this error. Please help me. thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh deformation in ANSYS Fluent DDPM | roopesh99 | FLUENT | 8 | June 2, 2016 10:44 |
Mesh deformation in ANSYS Fluent DDPM | roopesh99 | FLUENT | 0 | May 24, 2016 03:53 |
How to create matching mesh zones so that periodic boundary can be created in Fluent | cgoodale1 | STAR-CCM+ | 3 | February 29, 2016 12:34 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Periodic condition between ICEM and FLUENT | Touré | ANSYS Meshing & Geometry | 0 | August 5, 2012 17:00 |