|
[Sponsors] |
October 13, 2019, 04:26 |
Dynamic Mesh Settings
|
#1 |
New Member
jens meier
Join Date: Sep 2019
Posts: 28
Rep Power: 6 |
Hey all,
I'm working with a dynamic mesh that moves just in x-direction. I used the smoothed method with a spring. The problem is now, that the thickness of the mesh is getting very low (just at the side where the mesh moves) so that I get floating point exception error. Does anybody know what setting I need in order to make the mesh thin down uniformly ? Hope anyone can help me, thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
No rotation using dynamic mesh settings | Ahmed Saeed Mansour | FLUENT | 0 | April 21, 2018 19:10 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
[ICEM] 3D Dynamic Mesh - Boundary layer mesh issues | nathanricks | ANSYS Meshing & Geometry | 0 | September 23, 2015 05:14 |