 |
 |
 |
|
|
|
[Sponsors] | ||||
January 15, 2020, 04:25
|
Rectangular box with round inlet in 2D?
|
#1 |
|
New Member
Join Date: Jan 2020
Posts: 2
Rep Power: 0  |
Hi,
until now, i´ve done durability and stiffness simulations, so CFD is new to me. Now i have to do a 2D simulation of a rectangular box with an internal round velocity inlet (see attached graphic). The pipe of the inlet can be ignored in the simulation. So if you look from the side in 2D, there is just an edge left for the inlet. So far so good. But in my opinion this problem could not be solved in 2D, because there are not uniform shapes in the depth, because of the rectangular form of the box. Or how should i set up this problem? Thanks a lot and greetings, Flow_Newbie |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| multiphaseInterfoam non-constant inlet | kaaja | OpenFOAM Running, Solving & CFD | 4 | February 23, 2018 02:04 |
| massflow inlet on cooling plate definition inside the ambient air box | farianka | FLUENT | 0 | March 21, 2017 06:27 |
| [ICEM] Multi-Block Meshing of a Rectangular channel with inlet at 90 deg | khedar | ANSYS Meshing & Geometry | 0 | October 15, 2016 14:56 |
| Reusing the inlet time directories in timeVaryingMappedFixedValue | ngj_22 | OpenFOAM Running, Solving & CFD | 0 | January 24, 2013 10:22 |
| what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |
Threaded Mode
