|
[Sponsors] |
March 8, 2020, 05:49 |
ICEM CFD Mesh Generator & Fluent
|
#1 |
New Member
Vignesh
Join Date: Feb 2020
Posts: 19
Rep Power: 6 |
Respected Sir,
I am working on a FSI project, where I have a three limb pipe, which I have generated in the ICEM CFD mesh generator. when I import the geometry it shows the following error messages like "Floating point exception" and also in fluent it shows the error message as "Pressure information is not available at the boundaries" can anyone please help me out in this to solve the problem? Please notify me where I am lagging? i have also attached the screen shots of the error message. Capture1.JPG Capture.JPG Thanking You. Expecting a Reply from you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
FLUENT adding mesh nodes problem when importing 3D mesh from ICEM | guxin7005 | FLUENT | 2 | June 27, 2016 21:41 |
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent | sonic109 | ANSYS Meshing & Geometry | 2 | September 3, 2014 00:56 |
Boddy fitted Hexcore Mesh in ICEM Cfd | Mitch | CFX | 0 | December 29, 2008 06:07 |
prob while exporting icem cfd hexa mesh to fluent | mani | CFX | 4 | March 7, 2007 03:41 |