|
[Sponsors] |
Dialogue box appearing when I change settings during solution in the fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 25, 2020, 06:02 |
Dialogue box appearing when I change settings during solution in the fluent
|
#1 |
New Member
Mohamed Abdulazim
Join Date: Jun 2019
Location: Egypt
Posts: 11
Rep Power: 6 |
Hello everybody,
when I change some settings in the fluent during the solution such as turning off energy equation during the calculations, a dialogue box appears asking me whether I need to use setting changes for current calculations only or current and future calculations, I chose current and future calculations by default. Does that erase the previous calculations in energy equation or keep the results to be used in case of turning on the energy equation again. Frankly, I need to understand the difference between the two choices in the dialogue box. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Update failed for the Solution component in Fluid Flow (Fluent). The Solution compon | Faiz94 | FLUENT | 1 | June 10, 2019 16:17 |
Settings for sliding mesh or MRF in Ansys FLUENT | sgysin | FLUENT | 0 | September 26, 2018 14:39 |
How to change boundary conditions by judging the temperature of one point in fluent? | hotin87 | Fluent UDF and Scheme Programming | 16 | September 25, 2015 03:01 |
solution convergence and mesh density in k-omega model (FLUENT) | ripong | FLUENT | 0 | January 29, 2015 17:09 |
Solution calculations and convergence in Fluent | Freeman | FLUENT | 7 | May 3, 2009 22:26 |