Dialogue box appearing when I change settings during solution in the fluent

Mohamed Abdulazim · March 25, 2020, 06:02

Hello everybody,
when I change some settings in the fluent during the solution such as turning off energy equation during the calculations, a dialogue box appears asking me whether I need to use setting changes for current calculations only or current and future calculations, I chose current and future calculations by default. Does that erase the previous calculations in energy equation or keep the results to be used in case of turning on the energy equation again. Frankly, I need to understand the difference between the two choices in the dialogue box. Thanks in advance.

vinerm · March 25, 2020, 06:08

This will not erase any data. It just asks if you want to keep the newly made changes in the settings for the future or only for this particular run. You chose the right option.

Mohamed Abdulazim · March 25, 2020, 06:25

Thank you very much, Vinerm.

Basoule · May 15, 2023, 07:47

Hi,
I want to save change settings for current and future calculation.
However, the option is gray and I can't select it.
screenshot : https://ibb.co/xmcD2Cw

Before, I could select this option for my other case but I don't know why I can't for this one.
Could someone help me ?

Thanks

EDIT : it was a problem with the incoming mesh.

March 25, 2020, 06:08	Option	#2
vinerm Senior Member Vinerm Join Date: Jun 2009 Location: Nederland Posts: 2,946 Blog Entries: 1 Rep Power: 35	This will not erase any data. It just asks if you want to keep the newly made changes in the settings for the future or only for this particular run. You chose the right option. Mohamed Abdulazim likes this. __________________ Regards, Vinerm PM to be used if and only if you do not want something to be shared publicly. PM is considered to be of the least priority.

May 15, 2023, 07:47	save settings for future calculation not available	#4
Basoule New Member Basile Join Date: May 2023 Location: France Posts: 1 Rep Power: 0	Hi, I want to save change settings for current and future calculation. However, the option is gray and I can't select it. screenshot : https://ibb.co/xmcD2Cw Before, I could select this option for my other case but I don't know why I can't for this one. Could someone help me ? Thanks EDIT : it was a problem with the incoming mesh. Last edited by Basoule; May 16, 2023 at 07:30.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Update failed for the Solution component in Fluid Flow (Fluent). The Solution compon	Faiz94	FLUENT	1	June 10, 2019 16:17
Settings for sliding mesh or MRF in Ansys FLUENT	sgysin	FLUENT	0	September 26, 2018 14:39
How to change boundary conditions by judging the temperature of one point in fluent?	hotin87	Fluent UDF and Scheme Programming	16	September 25, 2015 03:01
solution convergence and mesh density in k-omega model (FLUENT)	ripong	FLUENT	0	January 29, 2015 17:09
Solution calculations and convergence in Fluent	Freeman	FLUENT	7	May 3, 2009 22:26

March 25, 2020, 06:25		#3
Mohamed Abdulazim New Member Mohamed Abdulazim Join Date: Jun 2019 Location: Egypt Posts: 11 Rep Power: 6	Thank you very much, Vinerm.