|
[Sponsors] |
May 11, 2020, 04:26 |
How to imrpove element quality?
|
#1 |
New Member
alimin shafie
Join Date: May 2020
Posts: 1
Rep Power: 0 |
Im still new in fluent and facing difficulties in my simulation especially meshing. Im using K-omega turbulance model hence i set the y+ = 1 but that results in a very low element quality at the near surface region where the aspect ratio is extremely bad. I trying to improve it by increasing the elements (around 1m elements) and the quality is as shown. Is there other method to improve the quality? also i think this resulting the fluctuating continuity plot.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] 3D Mesh conversion from gmsh-2.5.0 to OpenFOAM | Ancioi | OpenFOAM Meshing & Mesh Conversion | 17 | January 8, 2019 23:50 |
Identifying Markers in a CGNS Mesh | tjim | SU2 | 3 | October 12, 2018 01:21 |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
[ANSYS Meshing] Inflation layers element quality | frossi | ANSYS Meshing & Geometry | 0 | July 2, 2016 20:19 |
autoPatch error, mesh quality related...? | Alexvader | OpenFOAM | 0 | October 6, 2011 17:57 |