 |
 |
 |
|
|
|
[Sponsors] | ||||
|
|
June 6, 2020, 05:26
|
Help regarding FSI for arterial blood flow.
|
#1 |
|
New Member
Farhan Muhib
Join Date: May 2020
Posts: 2
Rep Power: 0  |
Hello,
I am trying to simulate blood flow through an artery using a Transient structural-Fluent coupling system. The simulation runs fine for Steel as Engineering Data. But when I change it for artery (very small Young's Modulus), the error saying "Excessive distortion on solid domain" shows up. I have followed previous threads similar to this and tried changing step size and mesh size but it did not help. Can anyone help who has solved this problem? Thanks! |
|
|
|
|
 |
| Tags |
| artery, blood flow, distortion, fluent, fsi |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blood flow in artery including FSI | viraj20feb | OpenFOAM | 3 | March 7, 2017 14:01 |
| blood flow FSI: Error detected by routine PEEKCS CDANAM | Nimish | CFX | 0 | April 22, 2015 10:53 |
| Blood flow with FSI in Ansys 12 | Marten | ANSYS | 9 | April 14, 2012 16:33 |
| Blood flow analysis | kmgraju | FLUENT | 0 | May 20, 2011 02:19 |
| FLUENT BLOOD FLOW RATE | Christoforos | FLUENT | 0 | September 18, 2008 10:08 |
Hybrid Mode
