[franc1]

Hi everybody,
I'm performing a thermal analysis over a 2D disk surface.
My aim is to refine the mesh along the radius of the disk in a specific way and bias factor is what i must use to do this task.

The problem is that i cannot draw a line along the radius on the mesh in which i have to apply the bias factor tho. Any suggestion on how to do it?
I think that the problem is quite trivial, but i just can't find a solution

Thank you in advance.

[franc1]

Nobody can help?

[mCiFlDk]

Originally Posted by franc1

Hi everybody,
I'm performing a thermal analysis over a 2D disk surface.
My aim is to refine the mesh along the radius of the disk in a specific way and bias factor is what i must use to do this task.

The problem is that i cannot draw a line along the radius on the mesh in which i have to apply the bias factor tho. Any suggestion on how to do it?
I think that the problem is quite trivial, but i just can't find a solution

Thank you in advance.

Hi franc1,


I can't think in other way to do what you want to. I would use Spaceclaim or Design Modeler to divide my geometry into two parts with a simple sketched line, and there you can use the bias factor.


Regards.

[franc1]

Thank you for reply mCiFlDk