|
[Sponsors] |
Transient and Steady state simulation results do not match |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Shahin
Join Date: May 2020
Posts: 12
Rep Power: 5 ![]() |
Hi
I have performed a two phase flow simulation both in transient and steady state. Once I run it in transient apparently there is no problem and I can see the flow regime is kind of a plug flow with a lot of up and down, but once I try the steady state simulation the residuals don't reduce and it does not look like it is converging (I have attached the picture). Does it mean that my transient simulation is wrong as well ? |
|
![]() |
![]() |
![]() |
Tags |
steady state, transient |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will the results of steady state solver and transient solver be same? | carye | OpenFOAM Running, Solving & CFD | 9 | December 28, 2019 05:21 |
The difference between steady state and transient | JuPa | CFX | 36 | December 9, 2019 22:50 |
Convergence in steady state simulations vs transient ones | cardioCFD | CFX | 5 | January 21, 2018 10:59 |
Transient simulation -> Steady state solution | saisanthoshm88 | CFX | 3 | October 31, 2014 10:29 |
Steady state simulation with transient partilcle tracking | mali28 | FLUENT | 2 | February 7, 2013 14:25 |