Fluent Meshing Mode

elochana · November 23, 2020, 10:45

Hello Everyone,

1. Before Ansys tookover, which software did Fluent users use for meshing and geometry modelling?

2. Was Fluent Meshing mode available before Ansys tookover Fluent? Or is it something Ansys added after acquiring Fluent?

Asking this because, Fluent meshing mode doesn't allow you to add named selections or boundaries, and you are required to create named selections on DM or SC. I would really like to model my geometries in CATIA V5 and directly use Ansys Fluent without anything else. Is this even possible?

Thank you

AlexanderZ · November 24, 2020, 02:34

check information about "Invoke Zone Separation by Angle" option in surface meshing tab, advanced options

before Ansys, people use Gambit to prepare mesh

November 23, 2020, 10:45	Fluent Meshing Mode	#1
elochana New Member Join Date: Jun 2011 Posts: 11 Rep Power: 15	Hello Everyone, 1. Before Ansys tookover, which software did Fluent users use for meshing and geometry modelling? 2. Was Fluent Meshing mode available before Ansys tookover Fluent? Or is it something Ansys added after acquiring Fluent? Asking this because, Fluent meshing mode doesn't allow you to add named selections or boundaries, and you are required to create named selections on DM or SC. I would really like to model my geometries in CATIA V5 and directly use Ansys Fluent without anything else. Is this even possible? Thank you Last edited by elochana; November 23, 2020 at 23:34.

November 24, 2020, 02:34		#2
AlexanderZ Senior Member Alexander Join Date: Apr 2013 Posts: 2,363 Rep Power: 34	check information about "Invoke Zone Separation by Angle" option in surface meshing tab, advanced options before Ansys, people use Gambit to prepare mesh elochana likes this. __________________ best regards ****************************** press LIKE if this message was helpful

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Fluent UDFs in Batch mode	hwvfn	FLUENT	1	July 14, 2022 10:03
[ANSYS Meshing] Need help optimizing my Fluent Meshing Workflow	DL598	ANSYS Meshing & Geometry	0	April 21, 2020 12:57
Save images using Fluent in batch processing mode	dixitked	FLUENT	8	August 29, 2019 12:25
Transfer named selections from SW to Fluent Meshing	the-sted	FLUENT	0	May 1, 2016 23:44
fluent stops batch mode on error	Ralf Schmidt	FLUENT	1	March 1, 2008 10:35