|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
harshavardhanps
Join Date: Dec 2020
Posts: 13
Rep Power: 5 ![]() |
I am using ANSYS FLUENT for my simulation. I am designing a low-speed open-type subsonic wind tunnel(Mach NO~0.1). I completed my geometry and meshing. Currently, I am using the following boundary conditions.
At Inlet: Patm(static pressure inlet= atmospheric gauge pressure i.e Patm=0 pa). At outlet: mass flow rate boundary condition. I am using a coupled solver I got struck in choosing a courant number? your help is much appreciated. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 92 | May 21, 2024 07:56 |
[General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 30 | November 6, 2023 21:00 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
foam-extend_3.1 decompose and pyfoam warning | shipman | OpenFOAM | 3 | July 24, 2014 08:14 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |