Exporting an area as a profile - Fluent

senolkupeli · February 17, 2021, 02:49

Hi,

I would like to export the heat flow over an area as a PROFILE from a steady state 3D simulation.

I load this Profile into another steady state 3D simulation. I would like to multiply the values for the heat flow from the PROFILE using a scalar. For this I would like to create an expression that contains the values of the profile. In the Ansys help page you can see that the profile can be used when writing the expression.

I attached an image. On the image you can see that, I don't have this tab.

Does anyone have an idea how to solve it?

Thanks for help!

Many Greeting

senolkupeli · February 19, 2021, 02:39

Hi,

The problem is solved by using ANSYS R2021.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Face area magnitude inconsistency when exporting	ReeKo	FLUENT	6	February 21, 2021 20:10
Log Profile UDF for FLUENT	sariug	Fluent UDF and Scheme Programming	2	August 15, 2016 05:58
Fully developed temperature profile for laminar/turbulent flow in FLUENT	raghu.tejaswi	FLUENT	10	November 7, 2012 09:57
Exporting structured mesh from ICEMCFD to Fluent?	jeevan kumar	FLUENT	1	January 23, 2012 11:21
Ansys FLUENT UDF - Velocity profile (of known values) across edge / surface	emmkell	Fluent UDF and Scheme Programming	2	October 21, 2011 13:12

February 19, 2021, 02:39		#2
senolkupeli New Member Join Date: Nov 2016 Posts: 2 Rep Power: 0	Hi, The problem is solved by using ANSYS R2021.