 |
 |
 |
|
|
|
[Sponsors] | ||||
Time-steps won't load from Fluent into CFD-Post. Can anyone please help? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 23, 2021, 03:44
|
Time-steps won't load from Fluent into CFD-Post. Can anyone please help?
|
#1 |
|
New Member
George Staley
Join Date: Jun 2021
Location: Manchester, England
Posts: 1
Rep Power: 0  |
I've seen other similar posts where CFD-Post won't display all time-steps in the time-step selector. I've tried selecting the last .dat file in my solution data, but it loads only that time-step. Plus when I load up CFD-Post initially, I get this error:
"ERROR Error reading file 'C:\Users\theon\OneDrive\University\Modules\Disser tation\CFD\Working Folder\LHTES Heat Transfer_files\dp0\FFF-3\Fluent\FFF-3.1.flprj': The run 'RunSteady' in simulation 'Simulation' contains transient output but no output files were defined." I've attached screenshots of the 'Load Results' process. |
|
|
|
|
|
| Tags |
| cfd-post, fluent |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| courant number increases to rather large values | 6863523 | OpenFOAM Running, Solving & CFD | 22 | July 5, 2023 23:48 |
| laplacianFoam with source term | Herwig | OpenFOAM Running, Solving & CFD | 17 | November 19, 2019 13:47 |
| Post processing in CFD Post or Fluent. | Blobs | OpenFOAM Post-Processing | 2 | June 26, 2016 07:23 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
Linear Mode
