|
[Sponsors] |
August 31, 2021, 02:35 |
Creating empty Surface
|
#1 |
New Member
Singapore
Join Date: Aug 2021
Posts: 13
Rep Power: 4 |
Hi all,
Can I check what does this means when the console states, 'Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface.'? Is this an error? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |
[snappyHexMesh] creating baffles using snappyHexMesh (for given random shaped surfaces) | ashish.svm | OpenFOAM Meshing & Mesh Conversion | 1 | January 17, 2018 01:24 |
Creating Volume mesh from surface mesh | Vivek.oswal | Mesh Generation & Pre-Processing | 0 | August 7, 2015 14:11 |
Error message when creating a surface | Ybes | FLUENT | 0 | February 8, 2006 10:54 |
creating volume from a surface file for CFD | Amir | Main CFD Forum | 0 | December 24, 2002 02:08 |