|
[Sponsors] |
Why fan boundary condition in ansys fluent is not operate at operating point |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 31, 2022, 11:58 |
Why fan boundary condition in ansys fluent is not operate at operating point
|
#1 |
New Member
Pattawee Aekarrechai
Join Date: Jan 2022
Posts: 1
Rep Power: 0 |
Hi,
I am trying to model and validate the air flow in simple circular air duct i place fan boundary condition at 0.1 m right before outlet as you can see my system in Pic.1. I set an inlet as Pressure inlet and outlet as Pressure outlet (Pic.2,3) and i specify my fan curve with piecewise-linear (Pic.4). I plot the result of simulation an average pressure distribute in each cross sectional area (Pic.5) then i plot my system characteristic curve with fan curve to determine where the operating point is (Pic.6). But as you can see from the simulation result it has system head 28.3 Pa but the fan provide head at 77.3 Pa. I have no idea why it is not operate at the operating point. Thank you in advance ** Blue circle dot is system head and blue triangle dot is system provide head ** I also try to extend the duct length but the result is still the same (attachment) Pic.1 https://drive.google.com/file/d/1J9D...ew?usp=sharing Pic.2 https://drive.google.com/file/d/1YDL...ew?usp=sharing Pic.3 https://drive.google.com/file/d/1Aii...ew?usp=sharing Pic.4 https://drive.google.com/file/d/1dHR...ew?usp=sharing Pic.5 https://drive.google.com/file/d/1tzU...ew?usp=sharing Pic.6 https://drive.google.com/file/d/1oOo...ew?usp=sharing |
|
Tags |
fan, fan analysis, fan boundary conditions, fluent, hvac |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Empty object Meshing and Fan boundary condition | cfd_user_pune | FloEFD, FloWorks & FloTHERM | 9 | May 29, 2024 15:35 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 09:44 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
[blockMesh] error EOF in blockMesh | Ahmed Khattab | OpenFOAM Meshing & Mesh Conversion | 7 | May 17, 2012 01:37 |