 |
 |
 |
|
|
|
[Sponsors] | ||||
How to create a chart with custom values for x & y axes? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 3, 2022, 07:31
|
How to create a chart with custom values for x & y axes?
|
#1 |
|
New Member
K. Sahai
Join Date: Jan 2022
Posts: 1
Rep Power: 0  |
This is regarding the parametric study of a gate valve where I vary gate rise and find output parameters. I have one input parameter, Gate rise (defined in SpaceClaim), and three output parameters, mass-flow-rate (defined in fluent), flow coefficient & flow factor (defined in CFD-post as an expression). The attachment below should provide some ideas.
I need to chart quantities as shown in the third attachment. Any help will be much appreciated. Valve geometry 1.png design points table.png Charted parameters.png |
|
|
|
|
|
| Tags |
| cfd - post, chart, custom chart axes |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TimeVaryingMappedFixedValue | irishdave | OpenFOAM Running, Solving & CFD | 33 | March 16, 2025 07:04 |
| Meshing a Sphere | Ajay | FLUENT | 10 | September 3, 2016 15:18 |
| Mapping values from 2D mesh to 3D mesh boundary during runtime | benk | OpenFOAM Programming & Development | 1 | June 13, 2014 03:39 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
| how to create chart in CFX post? | Oscar | CFX | 3 | June 29, 2005 10:15 |
Linear Mode
