flonum_arg detected NaN. Trying to continue with it. -- CFD Online Discussion Forums

October 17, 2022, 00:45

flonum_arg detected NaN. Trying to continue with it.

hbilal1076

New Member

bilal

Join Date: Oct 2021

Location: pakistan

Posts: 27

Rep Power: 4

Good time, I am using Ansys fluent 2022-R2 and modeled a 2D flame combustor, I compile a UDF file and run simulation and after 3 minutes I get the following error.

Warning: flonum_arg detected NaN. Trying to continue with it.

What could be the possible cause of this problem, even my mesh/orthognal quality is fine.

What do you advise?

Thank in advance.

Attached Images

error 50.jpg (103.7 KB, 7 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error running result	changshuqi	REEF3D	2	March 24, 2022 19:57
Fail to converge when solving with a fabricated solution	zizhou	FLUENT	0	March 22, 2021 06:33
fluent divergence for no reason	sufjanst	FLUENT	2	March 23, 2016 16:08
user subroutine error	CFDUSER	CFX	2	December 9, 2006 06:31
Could anybody help me see this error and give help	liugx212	OpenFOAM Running, Solving & CFD	3	January 4, 2006 18:07

All times are GMT -4. The time now is 07:33.