|
[Sponsors] |
November 16, 2022, 12:41 |
wss on stenosed wall
|
#1 |
Member
naji
Join Date: Nov 2022
Posts: 37
Rep Power: 4 |
hi guys
how should i get wss for mesh study? on a point/surface or line? this plot is wss in a specific time (for example 0.08seconds) i get different wss quantities. as you may know for this mesh study I'm using inflation layers i think the reason why it doesn't lead to a good mesh independence result and wss is increasing is layer length how can i create an equal inflation layer length for every mesh? Last edited by aiden_1995; November 17, 2022 at 09:34. |
|
Tags |
fluent, stenosis, transient, wall shear stress |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
chtMultiRegionFoam: two fluid regions separated by a thin, conducting wall | JayDeeUU | OpenFOAM Pre-Processing | 16 | July 22, 2021 22:17 |
[snappyHexMesh] How to draw a 3D-Drawing for Meshing | Kahnbein.Kai | OpenFOAM Meshing & Mesh Conversion | 4 | June 15, 2021 13:16 |
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 07:23 |
Patches for OpenFOAM 1.7 on MacOS X | gschaider | OpenFOAM Installation | 101 | September 21, 2011 06:37 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 13:03 |