|
[Sponsors] |
January 16, 2023, 00:49 |
File conversion
|
#1 |
New Member
Manas Kumar Bhukta
Join Date: Jan 2023
Posts: 1
Rep Power: 0 |
Whenever I set as CFD compatible option to auto save after every 2 time steps of transient problem in ansys fluent. There are two file extension format such as cas and cdat. But I wanna cas and dat file format for tecplot use. How can I get that?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |