Repeated error message for Fluent meshing when trying to enclose fluid regions

thehungrygraduate · May 22, 2022, 11:44

I have received this error multiple times during the described geometry workflow step in fluent meshing:

Error: A cap could not be created using the specified zone/label. Ensure your zone/label encloses the whole opening.
Error Object: #f

I have gone back into Spaceclaim to fix holes and inexact edges until I pass the geometry check. However, this has not fixed the problem. Are there any general steps I should take or is this type of error only relative to the geometry I am using? In other words, are there any easy fixes?

Pradyuman0007 · September 13, 2022, 04:15

Quote:

Originally Posted by thehungrygraduate

I have received this error multiple times during the described geometry workflow step in fluent meshing:

Error: A cap could not be created using the specified zone/label. Ensure your zone/label encloses the whole opening.
Error Object: #f

I have gone back into Spaceclaim to fix holes and inexact edges until I pass the geometry check. However, this has not fixed the problem. Are there any general steps I should take or is this type of error only relative to the geometry I am using? In other words, are there any easy fixes?

Were you able to solve the error? I am having the same problem and I'm new to Ansys. Help regarding the error will be greatly appreciated.

Mishra Apoorv · January 23, 2023, 14:35

Quote:

Originally Posted by Pradyuman0007

Were you able to solve the error? I am having the same problem and I'm new to Ansys. Help regarding the error will be greatly appreciated.

did you get the answer or found the problem? Can you help me out with the same?

May 22, 2022, 11:44	Repeated error message for Fluent meshing when trying to enclose fluid regions	#1
thehungrygraduate New Member Join Date: May 2022 Posts: 1 Rep Power: 0	I have received this error multiple times during the described geometry workflow step in fluent meshing: Error: A cap could not be created using the specified zone/label. Ensure your zone/label encloses the whole opening. Error Object: #f I have gone back into Spaceclaim to fix holes and inexact edges until I pass the geometry check. However, this has not fixed the problem. Are there any general steps I should take or is this type of error only relative to the geometry I am using? In other words, are there any easy fixes?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points	Simurgh	OpenFOAM Meshing & Mesh Conversion	4	August 25, 2023 07:58
Problem with isolated fluid Regions	zacko	CFX	2	February 8, 2017 02:34
isolated fluid regions were found	alfin	CFX	14	October 8, 2015 01:36
Fluid Regions donot communicate via "Attach" Boundaries	sdwijeya	STAR-CD	0	August 28, 2009 13:26
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11