|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Jeong hwan
Join Date: Oct 2023
Posts: 1
Rep Power: 0 ![]() |
Hi!
I am using a Partially Premixed Flame model with Fraction of Gas in Mixture (FGM) to simulate a propane-air mixture. My mixture fraction is set at 0.054, and the heat loss fraction is set to 0.7 via TUI. However, when I run the simulation, I'm not seeing temperature gradients in the regions without flames. Has anyone experienced this issue and can provide guidance on how to address it? Thank you. ![]() |
|
![]() |
![]() |
![]() |
Tags |
fgm, heat loss fraction, premixed flame, temperature |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
simulation flame propagation for premixed laminar flame in closed vessel | sinarQarun | CFX | 1 | June 7, 2016 01:05 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
Combustion in a flame premixed & laminar | Quasimodo | FLUENT | 0 | December 5, 2007 08:06 |
premixed laminar flame | JCRC | FLUENT | 2 | July 25, 2006 05:33 |
Simulating laminar premixed flame | Subhash | FLUENT | 0 | August 17, 2004 00:46 |