 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2024, 18:16
|
Mesh reading fails
|
#1 |
|
New Member
sajjan
Join Date: Jan 2016
Location: Nepal
Posts: 13
Rep Power: 10  |
Hello,
I generated a mesh in ICEM and trying to read in Fluent. It reads well in my local machine, but as soon as I upload my mesh in cluster and try reading the mesh, it gives me an error as follows: Error: unable to read co-ordinates of node 120000 Error: unable to read co-ordinates of node 120001 Error: unable to read co-ordinates of node 120002 Error: unable to read co-ordinates of node 120003 and so on..... I wonder if anyone had a similar issue before |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Problem with Mesh conversion from FLUENT Meshing to OpenFOAM | mn17jyf | OpenFOAM Meshing & Mesh Conversion | 3 | November 1, 2023 09:49 |
| [snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 12:38 |
| Cht tutorial in 15 | braennstroem | OpenFOAM Running, Solving & CFD | 197 | June 10, 2015 03:02 |
| [Commercial meshers] Mesh conversion from Ansys ICEM | fabian_korn | OpenFOAM Meshing & Mesh Conversion | 3 | February 24, 2010 08:19 |
| [Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 15:02 |
Linear Mode
