|
[Sponsors] |
need help to create the geometry of a J-shaped airfoil in two dimension |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 25, 2024, 11:39 |
need help to create the geometry of a J-shaped airfoil in two dimension
|
#1 |
New Member
sourena
Join Date: May 2023
Posts: 6
Rep Power: 3 |
hi
In ansys design modeler: By using the curve from points command, I create two curves and then i close the open ends with the line from points command. So far, everything is correct(image 1), but when I create suface from the edges ,the curves breaks at several points(image 2).(I import the sketch from solid works too but I faced the same problem too).anyone could help me please? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh]: problem create a wedge geometry | mn14cat | OpenFOAM Meshing & Mesh Conversion | 1 | August 3, 2022 10:34 |
Angled Airfoil Geometry Problem | pharva | Main CFD Forum | 0 | March 29, 2022 15:05 |
Geometry of RAE2822 airfoil | Abolfazl_cfd | Main CFD Forum | 0 | April 20, 2021 05:54 |
Ffd_control_point_2d | feiyi | SU2 | 4 | September 30, 2019 12:42 |
High drag for airfoil compared to XFOIL and wind tunnel data | Ry10 | SU2 | 15 | October 30, 2016 17:27 |