|
[Sponsors] |
February 28, 2000, 12:05 |
gambit
|
#1 |
Guest
Posts: n/a
|
I'm trying to mesh a geometry but I'm getting this message: check the skewnesses of you fasce meshes and make sure the face mesh sizes are not too large in areas of small gaps.
I checked the skewness and it's low enough. my problem is very similar to Andrew's and I tried all the suggestions that you guys gave him but it didn't work for me. thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Does Gambit has a maximum allowable grid number? | spartan1516 | ANSYS Meshing & Geometry | 7 | March 25, 2010 09:08 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
Problem starting Gambit | ViHAR MALViYA | FLUENT | 0 | November 10, 2006 10:26 |