|
[Sponsors] |
May 9, 2011, 13:43 |
polyflow
|
#1 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
Hy guys
what are the limitations for simulation through Polyflow? i mainly willing to know if it is possible to simulate through polyflow in all ranges of Reynolds number? (or it is appropriate just for low reynolds number) Many thank |
|
May 10, 2011, 11:35 |
|
#3 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
Hi Amir
How come?, would u explain a bit more, and besides,roughly speaking is there any limitation for the reynolds number as role of thumb for simulating through polyflow? |
|
May 10, 2011, 11:58 |
|
#4 |
Senior Member
|
Hey,
as you know, finite element method is recommended for problems that convection term is not dominated; although, there are new algorithm to improve that, but this method is usually used for solid medias. undoubtedly, the finite volume is more reliable for fluids especially in high Re No. I don't have any rules of thumb for that; I faced such problems few months ago. I am using OpenFOAM in linux to get rid of them. |
|
May 10, 2011, 13:10 |
|
#5 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
Hi Amir
so as i understand anyway polyflow is good for very low reynolds number ,any simulation concerning a relatively higher reynolds number (which normally happens in fluids) is not feasible to be done through polyflow, by the way, openfoam is based on f.e or f.v ? thank u Hamid |
|
May 11, 2011, 15:06 |
|
#6 |
Senior Member
|
Hi,
I guess that polyflow can also be helpful for moderate Re No. OpenFOAM is based on finite volume but as it's an open source code, you can also implement some F.E. algorithms like DQ on that. it's so flexible! regards, Amir |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
polyflow error | duton | FLUENT | 2 | June 21, 2021 05:47 |
Polyflow problem | Fani | FLUENT | 1 | March 5, 2015 00:14 |
polyflow, fluent, cfx | hamid1 | FLUENT | 0 | April 4, 2011 04:17 |
Polyflow helps | natuan74 | FLUENT | 0 | February 12, 2010 00:26 |
Polyflow VS C-mold | krishna | FLUENT | 0 | June 17, 2004 02:28 |