|
[Sponsors] |
I-DEAS CAD data import with boundary conditions |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 29, 2001, 17:59 |
I-DEAS CAD data import with boundary conditions
|
#1 |
Guest
Posts: n/a
|
Dear Fluent Users,
Has anybody ever tried to import I-DEAS CAD data with boundary definitions (i.e. inflow, outflow, wall boundaries) directly into Fluent without going through Gambit ? I managed to import I-DEAS CAD data, however boundary definitions were not imported. So I needed to import tha data into Gambit first, redefine the boundary conditions, export the mesh, and finally import it into Fluent. If possible I want to get rid of the preprocessing I had to make in Gambit. Any comments will be greatly appreciated. Yunus |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |