|
[Sponsors] |
interface warning message when running parallel |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 16, 2001, 10:22 |
interface warning message when running parallel
|
#1 |
Guest
Posts: n/a
|
I tried to run a model which contains a pair of interfaces using the parallel version of FLUENT. When reading in the case file, FLUENT generates some warning messages about "interface encapsulate...", does it mean I have to partitioned the grids such that the Interfaces are in a single partition?
Please advise. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to use setField to create sphere | sega | OpenFOAM Pre-Processing | 38 | January 13, 2022 00:39 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
OpenFOAM14 for Mac OSX Darwin 104 | gschaider | OpenFOAM Installation | 118 | July 20, 2008 05:19 |
[OpenFOAM] Could you please help me | liugx212 | ParaView | 4 | December 22, 2005 16:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |