|
[Sponsors] |
January 17, 2002, 13:06 |
streamlines problem
|
#1 |
Guest
Posts: n/a
|
Dear fluent users
I'm simulating a laminar flow liquid past a sphere, and I'm interested in the streamline function. The geometry is very simple, a circle ( 2D sphere) in the midle of a square; inlet velocity in the upper boundary, outflow in the downflow boundary condition. I obtain always streamfunction values from 0 to certain value from left to right. As the geometry is symetrical, I think that is wrong. I have also tried other boundary conditions (axis, symmetry) at left and right without success; I obtain the same values, even worse if I put a wall the stream function doesn't change. Am I doing something wrong? Thanks Newbie |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 08:27 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 05:43 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 09:39 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 15:52 |