Home > Forums > Software User Forums > ANSYS > FLUENT

negative cells

Mark Forums Read

Reply

Search this Thread

January 28, 2002, 01:27	negative cells	#1
Armin Gips Guest Posts: n/a	Hallo! I tried to mesh a 2 dimensional geometry with the pave scheme. When I checked the mesh it included negative cells. I deleted this mesh and meshed the geometry again (same parameter!) After that I checked the mesh again and it was okay. How can that happened? Yours Armin

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 05:50
[snappyHexMesh] snappyHexMesh aborting	Tobi	OpenFOAM Meshing & Mesh Conversion	0	November 10, 2010 03:23
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00
physical boundary error!!	kris	Siemens	2	August 3, 2005 00:32

All times are GMT -4. The time now is 02:34.