 |
 |
 |
|
|
|
[Sponsors] | ||||
February 24, 2002, 03:41
|
mass flow rate of a dispersion phase
|
#1 |
|
Guest
Posts: n/a
|
Hi, anybody,
I think you are so kind tell me that if I can calculate the mass flow rate of a dispersion phase at each outlet boundary. Now I'm simulating a separating device by FLUENT5.4. This device has two outlets. I want to know its separating efficiency. So I must know the mass flow rate at two outlets. Sincerely, Paul |
|
|
||
|
February 26, 2002, 00:19
|
Re: mass flow rate of a dispersion phase
|
#2 |
|
Guest
Posts: n/a
|
Use Display-->Particle-Track panel. Set report type as 'summary'. Then Fluent reports escaped zone and particle number etc.
Sincerely, Jinwook |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow rate not conserved in turbomachine, interface defined wrong? | wildli | FLUENT | 3 | September 15, 2022 13:19 |
| Mass flow rate: calculation v/s computation | beguxa | FLUENT | 5 | December 2, 2018 22:02 |
| UDF to measure Mass Flow Rate | a.lynchy | Fluent UDF and Scheme Programming | 31 | October 4, 2018 15:10 |
| particle, parcel and mass flow rate balance | flybird | FLUENT | 0 | May 24, 2007 11:44 |
| compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 2, 2003 00:32 |
Linear Mode
