|
[Sponsors] |
March 20, 2002, 11:00 |
Line problems
|
#1 |
Guest
Posts: n/a
|
Hi, I'm now post-processing on my 3D half annulus in the form of creating lines through the geometry (parallel to the Y axis) at regular axial intervals and producing x-y plots of the velocity, viscosity profiles etc. The geometry runs along the z axis, so I'm setting lines (surface>line/rake menu) at intervals along this which was ok until a certain distance along the z axis, where the lines are being displayed as just one or two dots. At further points along the z axis Fluent wont even create the line, giving an error. My coordinates for the lines are fine as far as I know (all I am changing after the first line is the z (axial) value) Any comments will be gratefully accepted!
|
|
March 20, 2002, 11:31 |
Re: Line problems
|
#2 |
Guest
Posts: n/a
|
Hi! We had problems with creating lines, if we had values from 0 to something and it worked, if we did it with 0.000001 to something. Dont ask me why. Yvonne
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
IdeasUnvToFoam Bug amp Fix | benru | OpenFOAM Bugs | 42 | November 13, 2009 07:59 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 21:45 |
[Commercial meshers] Several problems with the mesh conversion utility when converting the meshes from Gridgen | su_junwei | OpenFOAM Meshing & Mesh Conversion | 2 | July 26, 2008 23:58 |
[blockMesh] BlockMeshmergePatchPairs polyTopoChanger | benru | OpenFOAM Meshing & Mesh Conversion | 3 | June 29, 2008 21:24 |