 |
 |
 |
|
|
|
[Sponsors] | ||||
April 26, 2002, 20:28
|
Question on starting multiphase simulation
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I will use the Eulerian model of FLUENT 6.0 to simulate my problem. However, when I open the menu of Define>Models, I found that the menu for "Multiphase" is in gray, which means it can not be used. Could you please tell me why this happen? Thank you very much. |
|
|
||
|
April 26, 2002, 20:36
|
Re: Question on starting multiphase simulation
|
#2 |
|
Guest
Posts: n/a
|
Sorry, I already found the answer. Thanks.
|
|
|
|
||
|
April 30, 2002, 11:32
|
Re: Question on starting multiphase simulation
|
#3 |
|
Guest
Posts: n/a
|
Hi Derek!
I'm also working with the Euler-Euler-model. Do you like to share some problems..or better solutions? At the moment i can just tell that the Euler-euler.model in my case ignores walls (it looks like the flow just goes through the wall, very strange). What about you? Yvonne |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ANSYS CFX volume fraction definition for multiphase simulation | juliom | CFX | 11 | January 24, 2018 06:32 |
| Volume fraction in multiphase simulation | juliom | CFX | 2 | July 30, 2011 09:26 |
| Multiphase Simulation giving wrong results | niazaliahmed | STAR-CCM+ | 2 | June 17, 2011 01:41 |
| Starting a 3D URANS simulation from a converged 2D URANS simulation | Josh | Main CFD Forum | 2 | June 4, 2011 21:32 |
| multiphase simulation floating point error | vidhya | Main CFD Forum | 0 | April 11, 2011 00:18 |
Linear Mode
