|
[Sponsors] |
May 6, 2002, 12:40 |
outflow boundary condition control
|
#1 |
Guest
Posts: n/a
|
hi, everyone. I am running a case with one inlet but two outlets. The thing is that how should I set the flow rate weight, since I can not tell how much of the percentage of inflow will go through one specific outlet. What should I do? Thanks in advance.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
outflow boundary condition foe flow over a cylinder | Ardalan | Main CFD Forum | 0 | April 29, 2010 13:04 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
outflow boundary condition | Maziar Mahzari | CFX | 0 | May 8, 2006 03:23 |
Zero outflow boundary condition | sk | Main CFD Forum | 2 | February 12, 2006 23:21 |
The Boundary Condition about the Flat Plate | boing | Main CFD Forum | 1 | January 6, 2002 16:53 |