|
[Sponsors] |
May 22, 2002, 19:04 |
Species Transport Model- A question
|
#1 |
Guest
Posts: n/a
|
I am doing a multicomponent flow with no energy involved, but while activating the "Species-Transport" model, the energy equation gets activated.Why is this? Thanks to all.-Shankar.
|
|
May 22, 2002, 20:39 |
Re: Species Transport Model- A question
|
#2 |
Guest
Posts: n/a
|
Because desnsity is determined by the mass fraction of the species and gas-law. So, if your system is constant temperature, e.g. 300K, then ininitialiaze temperature as 300K and de-activate energy equation at the 'CONTROL-->SOLUTION' panel.
Sincerely, Jinwook |
|
May 27, 2002, 13:56 |
Re: Species Transport Model- A question
|
#3 |
Guest
Posts: n/a
|
Thanks Shankar.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
Species Transport with Multiphase flow in FBR | venkat | FLUENT | 1 | July 23, 2008 23:53 |
species transport model | soundar | FLUENT | 1 | February 3, 2005 14:13 |
3D species transport model - 1 | co2 | FLUENT | 1 | April 23, 2004 04:20 |
3D species transport model | co2 | FLUENT | 0 | April 21, 2004 14:41 |