 |
 |
 |
|
|
|
[Sponsors] | ||||
June 21, 2002, 09:30
|
Meshing problem in fluent
|
#1 |
|
Guest
Posts: n/a
|
Hai Fluent users,
When I tried to mesh a surface in gambit,it fails with the following warning "Out of memory while meshing face #" How to overcome this problem and mesh the particular surface. Whether this is related to hard disk memory capacity. With Regards, e.logesh |
|
|
||
|
June 24, 2002, 01:32
|
Re: Meshing problem in fluent
|
#2 |
|
Guest
Posts: n/a
|
Yeah I also think so... your grid is very fine so try to generate somewhat coarser grid.
|
|
|
|
||
|
July 11, 2002, 05:16
|
Re: Meshing problem in fluent
|
#3 |
|
Guest
Posts: n/a
|
I think you need to increase the capacity of Memory as well as Harddisk.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with modelling contact in ansys fluent 12.1 | mak86 | FLUENT | 16 | August 27, 2019 10:07 |
| MPI problem with fluent | aryanet | FLUENT | 17 | October 30, 2017 22:04 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
| [ICEM] Meshing problem from ICEM CFD to Fluent | cfdonlinederafa | ANSYS Meshing & Geometry | 2 | September 21, 2010 17:16 |
| Problem about Fluent on Linux | hbinma | FLUENT | 3 | July 6, 2008 11:49 |
Linear Mode
