|
[Sponsors] |
October 21, 2002, 23:42 |
2D mesh from Gambit
|
#1 |
Guest
Posts: n/a
|
Hi, Is there a possiblity to export the surface mesh from GAMBIT?I'm trying to create zonal hybrid mesh as one of the T-Grid tutorial says. I already have the volume mesh.But i'm not able to export the surface mesh from Gambit.please advice. Thanks in advance. Mavinakere.
|
|
October 23, 2002, 05:21 |
Re: 2D mesh from Gambit
|
#2 |
Guest
Posts: n/a
|
Normally, it should work fine.
Did you specify a solver? Try to specify Fluent5/6 as solver and export the mesh without the option 2D selected. It is a 3d surface mesh you want to export, not a 2d mesh. Laika, still orbiting |
|
October 23, 2002, 12:44 |
Re: 2D mesh from Gambit
|
#3 |
Guest
Posts: n/a
|
Well,It's a 3D mesh i understand..and i did specify the solver as fluent 5 and specified all the BC's as wall and an default continum was specified.but when i export..i read errors in exporting.If i specify half of the domain with the BC's and export,the specified BC's are not visible and the fluid continum type is rest of the unspecified domain.it's very strange.. Mavinakere.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Successive Mesh in Gambit | ashish | FLUENT | 0 | April 28, 2006 00:42 |
How to mesh a circle by Gambit? | Zhengcai Ye | FLUENT | 5 | March 24, 2006 01:04 |
[Commercial meshers] Mesh import from gambit | Kaushik Balakrishnan (Balakrishnan) | OpenFOAM Meshing & Mesh Conversion | 5 | April 21, 2005 13:42 |