|
[Sponsors] |
January 3, 2003, 08:01 |
heat source in a domain
|
#1 |
Guest
Posts: n/a
|
I am simulating the ventilation problem in a room. How can I place heat source in a proper manner? I tried to put source term thru fluid boundary condition panel. But it resulted in an unphysical heating in the room. (I think Fluent tried to place heat source in every cell of the domain.) Maybe some cells shoud be chosen to place heat but this does not sound a logical solution. Any idea will be appreciated....Or am I missing something??? thanx..
aydin |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 07:29 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
Source terms and heat source | rahulsharma | FLUENT | 0 | February 11, 2010 02:20 |
how to load the heat source to wall | david yang | Main CFD Forum | 1 | October 12, 2009 14:34 |
Missing heat source | Phil | FloEFD, FloWorks & FloTHERM | 9 | June 19, 2008 11:33 |