Home > Forums > Software User Forums > ANSYS > FLUENT

nodal temperature values

Mark Forums Read

Reply

Search this Thread

May 5, 2003, 09:19	nodal temperature values	#1
Mcgregor Guest Posts: n/a	I have looked through the user manual in hope of finding a method for accessing nodal temperature values for use in a UDF. I know you can access face and cell temperature values using F_T and C_T but is there a way of accessing nodal temperatures in a similar way? Can someone please help me!!!!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
[swak4Foam] adjust inlet temperature depending on values of monitor points (groovyBC)	braennstroem	OpenFOAM Community Contributions	2	May 31, 2011 14:45
temperature / enthalpy fields depending on type of fvPatchField	astein	OpenFOAM Programming & Development	0	June 28, 2010 08:10
An issue with temperature change in unsteady prob	Ashok kumar	FLUENT	1	January 13, 2009 05:34
Deformation of wall by temperature condition	Jay	FLUENT	0	April 14, 2007 19:06

All times are GMT -4. The time now is 11:46.