Can't figure which cell particle is going to -- CFD Online Discussion Forums

June 6, 2003, 13:55	Can't figure which cell particle is going to	#1
rookie Guest Posts: n/a	Hello All, Does anyone know what this error message means in the DPM? "Can't figure which cell particle is going to -- ABORT." Thanks a lot! rookie

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58
Can't figure which cell particle is going to -- AB	am	FLUENT	0	February 21, 2006 18:13
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Warning 097-	AB	Siemens	6	November 15, 2004 04:41
Can't figure which cell particle is going to?	Easycad	FLUENT	4	November 13, 2003 07:18

All times are GMT -4. The time now is 00:58.